Curriculum Vitaes

Takeo Tanaka

  (田中 武雄)

Profile Information

Affiliation
Professor, Faculty of Engineering Department of Mechanical Engineering, Osaka Sangyo University
Degree
Master of Engineering(Kansai University)
Doctor of Engineering(Kyoto University)

J-GLOBAL ID
200901054602603289
researchmap Member ID
1000107868

External link

Misc.

 110
  • Takaomi Matsutani, Tsuchika Yasumoto, Takeo Tanaka, Tadahiro Kawasaki, Mikio Ichihashi, Takashi Ikuta
    NUCLEAR INSTRUMENTS & METHODS IN PHYSICS RESEARCH SECTION B-BEAM INTERACTIONS WITH MATERIALS AND ATOMS, 272 145-148, Feb, 2012  
    Annular pupils for electron optics were produced using a focused ion beam (FIB), enabling an increase in the depth of focus and allowing for aberration-free imaging and separation of the amplitude and phase images in a scanning transmission electron microscope (STEM). Simulations demonstrate that an increased focal depth is advantageous for three-dimensional tomography in the STEM. For a 200 kV electron beam, the focal depth is increased to approximately 100 nm by using an annular pupil with inner and outer semi-angles of 29 and 30 mrad, respectively. Annular pupils were designed with various outer diameters of 40-120 mu m and the inner diameter was designed at 80% of the outer diameter. A taper angle varying from 1 degrees to 20 degrees was applied to the slits of the annular pupils to suppress the influence of high-energy electron scattering. The fabricated annular pupils were inspected by scanning ion beam microscopy and scanning electron microscopy. These annular pupils were loaded into a STEM and no charge-up effects were observed in the scintillator projection images recorded by a CCD camera. (C) 2011 Elsevier B.V. All rights reserved.
  • Takaomi Matsutani, Tsuchika Yasumoto, Takeo Tanaka, Tadahiro Kawasaki, Mikio Ichihashi, Takashi Ikuta
    NUCLEAR INSTRUMENTS & METHODS IN PHYSICS RESEARCH SECTION B-BEAM INTERACTIONS WITH MATERIALS AND ATOMS, 272 145-148, Feb, 2012  
    Annular pupils for electron optics were produced using a focused ion beam (FIB), enabling an increase in the depth of focus and allowing for aberration-free imaging and separation of the amplitude and phase images in a scanning transmission electron microscope (STEM). Simulations demonstrate that an increased focal depth is advantageous for three-dimensional tomography in the STEM. For a 200 kV electron beam, the focal depth is increased to approximately 100 nm by using an annular pupil with inner and outer semi-angles of 29 and 30 mrad, respectively. Annular pupils were designed with various outer diameters of 40-120 mu m and the inner diameter was designed at 80% of the outer diameter. A taper angle varying from 1 degrees to 20 degrees was applied to the slits of the annular pupils to suppress the influence of high-energy electron scattering. The fabricated annular pupils were inspected by scanning ion beam microscopy and scanning electron microscopy. These annular pupils were loaded into a STEM and no charge-up effects were observed in the scintillator projection images recorded by a CCD camera. (C) 2011 Elsevier B.V. All rights reserved.
  • M. Inoue(Setsunan Univ, M. Suganami(Setsunan Univ, Y. Hashimoto(Shin-nihon Denko, T. Iyasu(Shin-nihon Denko, H. Saito(APCO, K. Moroguchi(APCO, T. Tanaka
    Journal of Surfece Analysis, 18(2) 105-109, 2011  
  • 田中武雄, 和氣愼, 大中逸雄
    同志社大学PBL推進協議会発行ブックレット, 2, 2011  
  • M. Inoue(Setsunan Univ, M. Suganami(Setsunan Univ, Y. Hashimoto(Shin-nihon Denko, T. Iyasu(Shin-nihon Denko, H. Saito(APCO, K. Moroguchi(APCO, T. Tanaka
    Journal of Surfece Analysis, 18(2) 105-109, 2011