宇佐美 清章

Photo-alignment efficiency of polyimide containing azobenzene in the backbone structure (Azo-PI) is significantly enhanced by exposing the precursor (polyamic acid: Azo-PAA) film to alkyl-amine vapor prior to photo-alignment. In this study, we have investigated the relationships between the alkyl-amine vapor treatment time, the swelling ratio of Azo-PAA films, and the photo-induced in-plane anisotropy. We found that: the Azo-PAA film swells on exposure to alkyl-amine vapor, and the swelling finally saturates; and the photo-induced in-plane anisotropy is correlated very closely with the swelling ratio. In addition, we pointed out the importance of the process order of alkyl-amine vapor treatment and photo-alignment.

Unusual behaviour of the dark conglomerate (DC) phase seen in an oxadiazole-based achiral bent-core liquid crystal, which has not previously been reported for the DC phase of other liquid crystals, is described. Under polarising optical microscopy, we see no domains of opposite handedness in the ground state of the DC phase. However, it shows unusual transformations when an electric field is applied to the system. On increasing the electric field, at first the domains of opposite handedness become visible and then they grow in size and slowly the sample transforms to a monochiral or single-handed form which is followed by a nonchiral state at very high fields. The threshold electric fields required to achieve these changes are temperature dependent and the transformations are seen irrespective of the frequency of the applied electric field (100 Hz to 5 kHz), type of the waveform (sine, square and triangular) and the thickness (1.5 μm to 15 μm) or the geometry (planar and twisted) of the device used. Further, there is no field-induced high birefringence texture observed even though sufficiently large electric field (~22 V/μm) has been applied across the devices. The nature of the behaviour is investigated by various techniques such as optical microscopy, conoscopy, circular dichroic and Raman spectroscopies, electro-optics and dielectric spectroscopy. The possible physical phenomena behind these changes are discussed in detail. © 2014 Taylor &amp Francis.

We have succeeded in controlling the pretilt angle of liquid crystal (LC) molecules over the whole range of 0 to 90 degrees by using photo-aligned blend films of two azobenzene-containing polyimides (Azo-PIs) with and without side-chains. The Azo-PIs were synthesized from pyromellitic dianhydride and a mixture of 4,4'-diaminoazobenzene and 4-(4'-propylbi(cyclohexan)-4-yl)phenyl 3,5-diaminobenzoate (PBCP-DABA). PBCP-DABA is a diamine to introduce a side-chain structure into the polyimide. Defect-free uniform LC alignment was obtained in the pretilt angle (theta(p)) ranges of theta(p) <= 11 degrees and theta(p) >= 78 degrees. Previously, we reported that the pretilt angle can be controlled using pure photo-aligned films of Azo-PIs with different molar fractions of PBCP-DABA. For the pure photo-aligned films, the defect-free pretilt angle ranges were theta(p) < 5 degrees and theta(p) >= 85 degrees. These results suggest that the azimuthal anchoring strength of the blend Azo-PI film is stronger than that of the pure films of Azo-PIs with side-chains, at least for the pretilt angle range from 5 to 11 degrees. We found that the defect-free pretilt angle range can be extended by using the blend Azo-PI films instead of the pure Azo-PI films. (C) 2011 American Institute of Physics. [doi:10.1063/1.3624767]